Transmitter is back to front with FMS. Help!!

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

dragonfly - 15 May 2004 22:30 GMT

Hi. I just installed FSM on my computer and linked up my Zhen Hau PCM
4CH transmitter. The simulator programme recognizes the transmitter
but the throttle control on the simulator is on the right instead of
the left where it ought to be, and is, when I fly my electric
Dragonfly helicopter. Any idea how I can make the transmitter work
correctly on the sim would be greatly appreciated.

Reply to this Message

Six_O'Clock_High - 15 May 2004 22:38 GMT

There is a selection on the menu where you calibrate your 'joystick'. Just
before you go into the calibration mode there is a list of channels with
boxes next to them. You put your channel into the channel the software
thinks is throttle. I stopped playing with it a month or two ago.

> Hi. I just installed FSM on my computer and linked up my Zhen Hau PCM
> 4CH transmitter. The simulator programme recognizes the transmitter
> but the throttle control on the simulator is on the right instead of
> the left where it ought to be, and is, when I fly my electric
> Dragonfly helicopter. Any idea how I can make the transmitter work
> correctly on the sim would be greatly appreciated.

Reply to this Message

Ted Campanelli - 15 May 2004 22:39 GMT

On 5/15/2004 5:30 PM Ted shuffled out of his cave and grunted these
great (and sometimes not so great) words of knowledge:

Change the "Mode". You should be able to do it in the sim. It has been
awhile since I used FMS, but it should be in the calibration part. If
you can not change it in FMS, change it in your transmitter, just
remember to change it back before flying your electric helicopter.

Reply to this Message

Model Forum / Radio Controlled / Air Models / May 2004

Transmitter is back to front with FMS. Help!!