 |
 | Home | Contact Us | FAQ | Search & Site Map | Link to Us |
 | Sign In | Join | Other 45 Sites in Network |
| HomeDiscussion Groups General ModelsRailroadsRocketsRadio Controlled Air ModelsHelicoptersLand ModelsWater ModelsModelGeeks.com Contact UsLink To UsSearch & Site Map |
Model Forum / Radio Controlled / Air Models / February 2007Laser cut parts for Sarpolus designs
Anyone know of a source for laser cut rib parts for Sarpolus designs Clean Cut in Model Aviation a few years ago?? Thanks and regards to all, Frank Schwartza Frank, I find all the fiberglass parts listed at Fiberglass Specialties, but can't find a specific laser cutter who's got the ribs already cut. However, most all of the laser cutters oughta be able to cut you some ribs if you supply the plan. There are several kit cutters who advertise in R/C Report. Geoff >Anyone know of a source for laser cut rib parts for Sarpolus designs >Clean Cut in Model Aviation a few years ago?? >Thanks and regards to all, >Frank Schwartza > Geoff: I found Dick Sarpolus' email and sent him a messae. He came right back and said he knew of no one who cut those particular ribs...and then said he cuts them by hand himself...so if it is good enough for the desgiiner, then it it certainly is good enough for me...Iwas just taking the lazy way out... Thanks, Frank If your looking for laser cutting, we have 13 laser systems. We're one of the largest in the midwest. Our site is http://www.lasercuttinginc.us or call us at (800) 471-2600 George > Geoff: I found Dick Sarpolus' email and sent him a messae. He came > right back and said he knew of no one who cut those particular [quoted text clipped - 3 lines] > Thanks, > Frank Thank you. There is a local who cuts laser balsa kits. I was hoping to find someone who had the rib sections already in file who could run them without the expensive set up charge. Thank you. Frank >If your looking for laser cutting, we have 13 laser systems. We're one >of the largest in the midwest. Our site is >http://www.lasercuttinginc.us or call us at (800) 471-2600 > Thank you. There is a local who cuts laser balsa kits. I was hoping > to find someone who had the rib sections already in file who could [quoted text clipped - 7 lines] > > - Show quoted text - I can help you with this project. A lot of times we can work with people on the setup charges to bring them down to a minimum. If your interested you can contact us. Our site is http://www.lasercuttinginc.us or call us at (800) 471-2600 |
Reply to this Message |
 Sign In
 Join
 My Latest Posts My Monitored Threads My Blog My Photo Gallery My Profile My Homepage Start New Thread Enable EMail Alerts Rate this Thread
|
©2012 Advenet LLC Privacy Policy - Terms of Use
This website includes both content owned or controlled by Advenet as well as content owned or controlled by third parties.