Helicopter Spec in Test:
- Walkera No. 35 RC Helicopter 6CH (SAME HELI LIKE THIS ONE:
http://www.hobbyjapan2000.com/store/proddetail.php?prod=DRAFL35)
- Power: Li-ion 1800mah battery
- Speed control: Original (Stock)
- Gyro: Stock Walkera Gyro
- Transmitter / Receiver: Walkera Stock Transmitter & Receiver
Test Comment:
1. I have tried the stock NIMH battery, not very good. Very short in
flying - about 5 minutes after the battery fully charged. NOT
RECOMMEND.
2. 2200mah battery is kind of big, so do not use that in test. The
2200mah battery can not fit the helicopter battery holder. Need to
attached it under the battery holder. So not very good.
3. Tried the li-ion 1800mah battery, very good result - lift up the
helicopter very fast and hovering is very stable, lot better than I can
expected for this kind of money I spent ($199 when I buy). The
helicopter is very powerful with this battery. The size of the battery
just fit into the battery holder perfectly. RECOMMENDED.
Others:
This helicopter need some setting and trimming when Irecieved it. Need
to trim the helicopter to make it fly better. I also adjust the main
blade angle to make it hovering better in air.
>> Tip: to adjust the angle of the main blade, you need to unlock the
no. 8 dip switch on the back of the transmitter, and adjust the PLT and
PZT to find the correct and most stable angle, so you can lift up the
helicopter into air fast and fly it more stable. It will take you some
time to find the correct angle - you can hold it in hand to feel the
lift up power to find the good angle. Try it couple time and you should
have some sense of finding the correct angle.
Li-ion Battery Charging: Be careful with the li-ion battery charging.
When you are charging the li-ion battery, pay attention to it. When
light change on the charger (GREEN), disconnet the battery to avoid any
damage to the battery. I have blow up a li-ion battery. So be careful
with that.
Before you fly: Check the helicopter careful to make sure all parts are
good and tight. This will avoid some accident. Do not get one yet, but
my experience in nitro helicopter tought me that.
Battery charging caution: For li-ion battery, before yo charge the
battery, you must make sure there is not damage on the battery,
especially if you crash the helicopter. Make sure the battery is good
and not damage before charge. A battery can be damage in result of
crash. Charging a damaged battery can be very very danger, it may blow
up (FIRE). So always be careful with that. Li-ion and li-po battery is
the very high powerful battery, so be safe.
Flying time: Try to take a break to let the motor cool down when the
motor get hot. I have burned out 1 motor already, because it is very
very hot when I fly the heli for very long time. So be careful of the
flying time and let the motor cool down, so you can save some money to
buy a new motor.
Overall: Good helicopter for it's low price. Better than I expected.
Not as powerful as the nitro heli. But worth it to buy one if your
budget is limited.
Jennifer Smith - 16 Mar 2005 21:54 GMT
Hi GTY
> Helicopter Spec in Test:
> - Walkera No. 35 RC Helicopter 6CH (SAME HELI LIKE THIS ONE:
[quoted text clipped - 8 lines]
> flying - about 5 minutes after the battery fully charged. NOT
> RECOMMEND.
Sounds familiar :) Same as with all the other electrics I saw so far. How
much flying time do you get out of the LiPo?
> [...lots of good info snipped...]
>
[quoted text clipped - 3 lines]
> flying time and let the motor cool down, so you can save some money to
> buy a new motor.
Have you tried adding a heat sink to the motor? Since it's sitting outside
the canopy (which I believe is a good idea), it should be possible to get a
heat sink onto it to keep it cool during flight.
Also, have you flown it outside? How sensitive is it to wind?
Again, thanks for the info
J
GTY - 19 Mar 2005 16:47 GMT
> Hi GTY
>
[quoted text clipped - 30 lines]
> Again, thanks for the info
> J
The flying time is 22 minutes for the 1800mah li-ion for mine. I do not
use the Heat Sink, but I will try it couple days later.
David.Gurua@gmail.com - 01 Apr 2005 21:03 GMT
Thanks for the advice. I got one of this helicopter
http://www.hobbyjapan2000.com/store/proddetail.php?prod=DRAFL35
Received in 5 days after order, very fast service.
I have tested the helicopter, spent about 10 minutes to trim the
helicopter. I can hover it for about 23 minutes. Working good as far.
Thanks GTY.
David.Gurua@gmail.com - 01 Apr 2005 21:05 GMT
Thanks for the advice, GTY. I got one of this heli:
http://www.hobbyjapan2000.com/store/proddetail.php?prod=DRAFL35
Received it 5 days after order, fast service than I expected. The
helicopter looks good when I received it. Spent 10 minutes to trim the
helicopter. Hover for about 23 minutes, so far so good. I like it.
NYPT Man - 07 Apr 2005 23:22 GMT
The #35 Walkera Heli with 1200mah is tested and good too. Very light in
weight.
Timmy - 17 Apr 2005 15:32 GMT
> > Hi GTY
> >
[quoted text clipped - 41 lines]
> The flying time is 22 minutes for the 1800mah li-ion for mine. I do not
> use the Heat Sink, but I will try it couple days later.
Got one from hobbyjapan2000 in last Monay and received in Friday -
that's fast :)
Tested the helicopter and was surprised. Very stable fly and lift up is
good and I like this helicopter. Just the heli cover is not good
looking, so I am going to print it like a CBC NEWS helicopter, haha.
ANy one know how to print label / sticker in computer?
Jennifer Smith - 19 Apr 2005 17:11 GMT
> [...snipped...]
> Got one from hobbyjapan2000 in last Monay and received in Friday -
[quoted text clipped - 4 lines]
> looking, so I am going to print it like a CBC NEWS helicopter, haha.
> ANy one know how to print label / sticker in computer?
There are transparent stickies for inkjets, I've seen them at local stores.
No idea how good they are though, I've never tried them. Just use your
favorite graphics program to create and collate the images.
J
leadsinga - 17 Apr 2005 21:46 GMT
Hi GTY,
Have one of these myself, got it a week or so ago n loving learning t
fly.
This comment you made!!
>> Tip: to adjust the angle of the main blade, you need to unlock the
no. 8 dip switch on the back of the transmitter, and adjust the PL
and
PZT to find the correct and most stable angle, so you can lift up the
helicopter into air fast and fly it more stable. It will take you some
time to find the correct angle - you can hold it in hand to feel the
lift up power to find the good angle. Try it couple time and yo
should
have some sense of finding the correct angle.
How do I do that??????? anyone????? keen to test this :)
Cheers
Mu
--
leadsing
whitty7628 - 18 Apr 2005 06:45 GMT
I recieved this heli yesterday and it hovered out of the box. So far I
am happy with this purchase. I can see that the servos and canopy will
need to be replaced but all in all it was a good value.

Signature
whitty7628