Raptor tail set up

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

R A Wright - 25 Aug 2005 22:24 GMT

I have just got to the stage of fitting the digital servo on a Raptor 50v2
I'm putting together, as I have been following the instructions which give
clear length of servo arms for the pitch etc, but as I'm fitting a quick uk
digital servo and rod I don't know what to set the tail pitch at so as not
to get a nasty surprise when it takes off. I assume so long as I get the
travel equal the heading hold csm 560 gyro will take care of it, but I want
to set it up mechanically to be ok without heading hold. could anyone
explain how to set the tail rotors to compensate for the main rotors thanks

Rob

Reply to this Message

R A - 25 Aug 2005 23:26 GMT

I found the answer here http://www.raptortechnique.com/ thanks to A1 who
told me about this site a while ago, I was not looking hard enough :-)

>I have just got to the stage of fitting the digital servo on a Raptor 50v2
>I'm putting together, as I have been following the instructions which give
[quoted text clipped - 6 lines]
>
> Rob

Reply to this Message

Model Forum / Radio Controlled / Helicopters / August 2005

Raptor tail set up