Airtronics 92777 receiver question

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

dstaffor[SpamNot] - 24 Sep 2003 17:00 GMT

My RD6000 radio system came with a 7 channel
receiver. From what I understand, the 7th
channel position normally has the receiver
battery plugged into it. In order to use the
7th channel, a Y adapter must be used. My
question is this: can I use the 7th channel
to control my GV-1 governor speeds?

DS

Reply to this Message

Beav - 27 Sep 2003 23:37 GMT

> My RD6000 radio system came with a 7 channel
> receiver. From what I understand, the 7th
[quoted text clipped - 3 lines]
> question is this: can I use the 7th channel
> to control my GV-1 governor speeds?

It depends on what the 7th channel does. If it's a rotary channel, you'll be
able to use the gov proportionally where the knob "dials in" any speed
between low speed (S1) and highest speed (S3) that you've programmed into
the gov.

If it's an "on-off" switch, it's not much use (IMO) but if it's a "two
conditions" switch (like the retract switch) then yep, you can set two
indivdual speeds with it.

Signature

Beav

Please note my E-mail address is "beavis dot original at ntlworld dot com"
(with the obvious changes)

Beavisland now lives at
www.beavisoriginal.co.uk

Reply to this Message

Model Forum / Radio Controlled / Helicopters / September 2003

Airtronics 92777 receiver question