GV1 and Concept VR

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

Andrzej Kostkiewicz - 17 Dec 2003 19:55 GMT

Hi freinds

Is here someone who fit a GV 1 to Concept VR . I have some problems with
this , is no place to fit sensor .. Have You some idea ??

Best Regards

Andrzej ( Poland )

Reply to this Message

Siberian Goose - 24 Dec 2003 14:28 GMT

Have you looked to see if there any after market alloy fans available with
magnet holes machined out of them.
Perhaps Quick UK make one.
Look at www.quickuk.com as they probably make one.

Phil.

> Hi freinds
>
[quoted text clipped - 4 lines]
>
> Andrzej ( Poland )

Reply to this Message

Beav - 24 Dec 2003 16:45 GMT

> Have you looked to see if there any after market alloy fans available with
> magnet holes machined out of them.

The magent holes (or lack of them) aren't the problem with the Concepts.
It's the position of the clutch. IT goes on before the cooling fan, which is
a good 3/4 inch further out along the shaft (now there's a thought!!). This
makes getting TO the fan, which is also inside a VERY tight shroud (Mmmm,
mind's working overtime here:-) a bit on the difficult side.

Not impossibly so, but it IS a pain in the arse.

Signature

Beav

Please note my E-mail address is "beavis dot original at ntlworld dot com"
(with the obvious changes)

Beavisland now lives at
www.beavisoriginal.co.uk

Reply to this Message

Model Forum / Radio Controlled / Helicopters / December 2003

GV1 and Concept VR