JR and Hitec 945 Servo

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

Wind and Snow - 22 Sep 2004 21:10 GMT

Hi,

Is there any problem with using a JR XS3 radio and reciever with Hitec
servos? I have hitec a 945 steering and 925 throttle servo and need a
radio/reciever. i was going to buy a JR XS3 and plug those servos in. want
to make sure i am not going to break anything? sorry if this is a dumb
question. i am a little new to this.

Thanks for the help.

Cheers

Paul

Reply to this Message

Justin Mahn - 22 Sep 2004 22:17 GMT

I have a R300 receiver and it works fine with my Hitec 945 servo.

Signature

Justin Mahn
remove Panties to e-mail

> Hi,
>
[quoted text clipped - 10 lines]
>
> Paul

Reply to this Message

Wind and Snow - 23 Sep 2004 12:58 GMT

Thanks Justin. Just wanted to be sure.

Regards,

Paul

> I have a R300 receiver and it works fine with my Hitec 945 servo.
>
[quoted text clipped - 12 lines]
> >
> > Paul

Reply to this Message

Justin Mahn - 23 Sep 2004 17:32 GMT

just make sure the negative wire (brown or black in most cases) is to the
outside of the receiver. depending on the connector you get you may have to
trim the futaba key off or bevel the corners to get a good fit.

Signature

Justin Mahn
remove Panties to e-mail

> Thanks Justin. Just wanted to be sure.
>
[quoted text clipped - 18 lines]
>> >
>> > Paul

Reply to this Message

Model Forum / Radio Controlled / Land Models / September 2004

JR and Hitec 945 Servo