I have a computerized Futaba 3PM 3-channel FM transmitter. I am using
Eight 2300mAh NiMh AA batteries with the transmitter. I bypassed the
transmitter's charge jack diode and I can now use my SuperBrain peak
charger to charge the NiMh batteries.
Is there a limit on a safe charge rate that I can use to charge my
batteries without damaging the transmitter? I know that my batteries
are designed to charge at up to a 2A charge rate but I am not sure if I
would damage the transmitter when trying to charge at that rate. I was
thinking about charging at 1A.
Ted Campanelli - 01 Apr 2005 20:51 GMT
Ted shuffled out of his cave and grunted these great (and sometimes not
so great) words of knowledge:
I would either remove the batteries for charging or not exceed the 1 amp
rate. Your typical "wal-wart" charger is only putting out about 100 mah
on the transmitter side and about 50 mah on the receiver side.
> I have a computerized Futaba 3PM 3-channel FM transmitter. I am using
> Eight 2300mAh NiMh AA batteries with the transmitter. I bypassed the
[quoted text clipped - 6 lines]
> would damage the transmitter when trying to charge at that rate. I was
> thinking about charging at 1A.
Chris Dugan - 01 Apr 2005 21:27 GMT
As Ted said, stick to 1A; the wiring inside the TX can't handle much more
than that without getting too warm.
It is especially not a good idea if you are charging loose cells as the
battery contacts will deteriorate and cause false peaks after a short time
so if they are not allready get the cells made up into a pack, soldered or
welded whatever you can get done.
Chris
pat - 02 Apr 2005 01:24 GMT
you could do 2A for a fast charge,but i would charge them at 1A or .5
overnight, those batteries will last longer and will live longer if ya
baby them, i never let mine die and then slow peak after c couple o hurs