> > Well then...swap to some MT tires and slap on a lower tooth bell!
> Tried that. Ran some Imex Romulin full-offset wheels with HPI Dirt Bonz and
> 12T (the smallest). Melted the clutch shoes (again)! I had previously
> melted a set with 14T bell (set up for buggy wheels).
>
> Doc
Is there some kind of high stress,high heat /rpm replacement shoes you could
use?
I'm not familiar with alot of the shoes on the market.
Would the 6065 or 7075 shoes work? (seen them from Nova)
Iridium - 01 Dec 2006 16:18 GMT
>> > Well then...swap to some MT tires and slap on a lower tooth bell!
>
[quoted text clipped - 10 lines]
> I'm not familiar with alot of the shoes on the market.
> Would the 6065 or 7075 shoes work? (seen them from Nova)
Hong Nor long life silver Alu shoes. They're unkillable - seriously, I
highly recommend them as an investment...

Signature
Dan
Formerly DanTXD
Doc - 02 Dec 2006 02:19 GMT
>> > Well then...swap to some MT tires and slap on a lower tooth bell!
>
[quoted text clipped - 10 lines]
> I'm not familiar with alot of the shoes on the market.
> Would the 6065 or 7075 shoes work? (seen them from Nova)
Maybe. I didn't want to kill a set of $25 shoes (I have a few sets of Mugen
Alu shoes laying around) while experimenting though. The performance with
the 12T bell was doggy enough to tell me that I'll need a bigger spur if I
want to run the MT tires though. It was still plenty fast, but not as
"zippy" as with the smaller diameter tires.
Doc