Bench drill free to good home

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

John Stevenson - 30 Jul 2005 12:38 GMT

Subject line say's it.
In the process of clearing out the workshop and papers of Myfords old
Development Engineer who has recently died.
This drill was built around WWII from castings and machined up at
Myfords.
Rather crude looking but it works, because you can buy a Chinese bench
drill for £9.99 with a £10.50 rebate it's hardly worth advertising.
Single phase with 1/2" Jacobs chuck, direct fitting, no taper.

Free to good home, even free to a bad one.
Mug, sorry, new owner must collect. Will fit into normal car or
because I'm desperate to get rid without scrapping it, it will even
fit into a Reliant.
--
Regards,

John Stevenson
Nottingham, England.

Visit the new Model Engineering adverts page at:-
http://www.homeworkshop.org.uk/

Reply to this Message

Bill H - 30 Jul 2005 13:59 GMT

>Subject line say's it.
>In the process of clearing out the workshop and papers of Myfords old
[quoted text clipped - 9 lines]
>because I'm desperate to get rid without scrapping it, it will even
>fit into a Reliant.

I'll collect it if its not gone yet.

Bill H
Derby

Reply to this Message

John Stevenson - 30 Jul 2005 14:06 GMT

>>Subject line say's it.
>>In the process of clearing out the workshop and papers of Myfords old
[quoted text clipped - 14 lines]
>Bill H
>Derby

Bill it's yours.
Collecting it this afternoon [ just leaving for another trip ]
email me about collection.
Tonight or tomorrow will be Ok or anytime next week.

--
Regards,

John Stevenson
Nottingham, England.

Visit the new Model Engineering adverts page at:-
http://www.homeworkshop.org.uk/

Reply to this Message

Model Forum / General / Models / July 2005

Bench drill free to good home