Stent Tool and Cutter Grinder

Stent Tool and Cutter Grinder - Magazine Article

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

Martin Evans - 28 Dec 2006 13:48 GMT

Has anyone access to the original (Model Engineers Workshop) magazine
article on the Stent grinder and could run me off either a scan or a
copy?

Is there a mail list for builders of the Stent such as exists for the
Quorn "20 years of ball handle turning, 3 kids, 2 workshops, a divorce
and a funeral" design?

Signature

The reply email address is a spam trap. To reach me direct substitute
mail for news.

Reply to this Message

Dick Gays - 28 Dec 2006 15:14 GMT

> Has anyone access to the original (Model Engineers Workshop) magazine
> article on the Stent grinder and could run me off either a scan or a
[quoted text clipped - 3 lines]
> Quorn "20 years of ball handle turning, 3 kids, 2 workshops, a divorce
> and a funeral" design?

Martin,

I have every copy and am willing to oblige. However a quick scan on
Colin Ushers MEW index only brings up two entries for Stent, one a
letter in issue 99 Scribe a line, and the second an article by Giles
Parkes in MEW 108 entitled "Stent Modifications". Neither sound like
what you are asking for.

Dick Gays, Leicester, UK.

Reply to this Message

Tony Jeffree - 28 Dec 2006 15:31 GMT

>> Has anyone access to the original (Model Engineers Workshop) magazine
>> article on the Stent grinder and could run me off either a scan or a
[quoted text clipped - 11 lines]
>Parkes in MEW 108 entitled "Stent Modifications". Neither sound like
>what you are asking for.

If you look in the ME index, it would seem that the construction
articles are in issues 3910, 3912, 3914, 3916, 3918, 3920, and 3922.
(part Vol 167, part vol 168), and not in MEW at all. So I don't have
them (I gave away my ME collection a while back).

Regards,
Tony

Reply to this Message

Model Forum / General / Models / December 2006

Stent Tool and Cutter Grinder - Magazine Article