Model Forum / General / Models / May 2008

 Best I can offer is secondhand info.

 The guy I talked to that had one, went back to his regular torch.

 If you are welding larger items, your knuckles spend a lot of time
very near the weld zone.

 When cutting, even more so.

 I've never used one, and like as not, never will.

 Frankly, I figure the cost differential between a regular torch and
this one, would be better spent on other things, perhaps a set of
jewellers torches or some other tool that would see use.

 Cheers
  Trevor Jones

Havent used one myself , but I am a member of an online forum where I'm
sure I have read something about these torches .
I have done some searches on the forum to see if I could find the thread
, but to no avail.

Here is the link to the forum ,you are welcome to post the link to the
torch on the forum an ask for any information on the performance of the
torch
http://www.woodworkforums.com/index.php

Hang on you say !!! That's a woodwork forum , well yes it is ,but it has
a metal work forum also ,and this is where I'm sure I read the info on
the torch .Just look along under the main header bar and second from the
right you will find the metal work button .

Sorry I couldn't help more

"The conventional Oxy/Acetylene torch relies on swaged tips which
roughly mix the gas after leaving the tip"

"The DHC 2000  Torch is totally the opposite,  it has a precision mixing
chamber inside the hand piece  which mixes the gases at equal low
pressure and low velocity  before  leaving the tip, resulting in an
extremely narrow concentrated heat affected zone."

Both of my welding torches simply don't do that - like the DHC torch,
the gases are premixed in the nozzle.

My cutting torch does (sort-of) mix the gases after the nozzle, but
that's different.

Can't see the main attraction, but I haven't used one.

-- Peter Fairbrother

Many thanks to all who replied to the post.

Several hours have been spent since my post on the Internet via forums
in the US, AU, UK, the main thread that has come through is that this
is a old query that comes up from time to time with no firm
conclusion.

It is my believe (possibly incorrect) that there an very few in the UK
or the owners have no Internet connection or do not read news groups,
and/or possibly choose not to inform anyone.

The end result is that someone has lost a sale.

Once again thank you all

Silvercrest

That is the Dillon or Henrob torch. I have one and have had it for a fair
number of years. A good torch for reasonably fine work (as opposed ot the
big BOC Comet torch). The torch is fairly heavy and chunky, but it is
easuer than my big torch for ali welding (but Tig is better still). The
cutting torch sucks. Your hand is to close to the work, and you keep losing
the cut with a lack of preheating, and it is awkward. I ended up buying an
old Meteor cutting torch for cutting jobs. Much, much easier to use.
Overall, not worth the premium against a lot of other torches on the market
- I have a small Meco Avaitor Jet torch which IMO is just as good and
lighter. Cutting torch is much better as well.
Geoff