Automatic centre punch

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

Richard Tanner - 10 Feb 2009 17:20 GMT

I have a Moore and Wright automatic centre punch which sadly is missing the
little ball that is so small and yet so important. I contacted M&W some
years ago but heard nothing and have just come across it again.

It would be very useful and I was wondering if anyone knew the diameter of
the ball and where I might buy one/some?

Any help appreciated.

Richard Tanner

Reply to this Message

petercolman45@hotmail.com - 10 Feb 2009 22:12 GMT

On Feb 10, 5:20 pm, "Richard Tanner" <richardtann...@orange.net>
wrote:

> I have a Moore and Wright automatic centre punch which sadly is missing the
> little ball that is so small and yet so important. I contacted M&W some
[quoted text clipped - 6 lines]
>
> Richard Tanner

You will be able to buty any size of bal from Atlas in Bloxwich
Peter

Reply to this Message

Richard Tanner - 11 Feb 2009 18:56 GMT

<petercolman45@hotmail.com>

>You will be able to buty any size of bal from Atlas in Bloxwich
>Peter

I Googled Atlas Bloxwich and got all sorts of things, could you give me
anymore info on them please.

Richard Tanner

Reply to this Message

Richard Tanner - 11 Feb 2009 19:58 GMT

> I Googled Atlas Bloxwich and got all sorts of things, could you give me
> anymore info on them please.

And then I put ball bearings into the search and lo and behold there they
were.

Thanks for your help.

Richard Tanner

Reply to this Message

Model Forum / General / Models / February 2009

Automatic centre punch