Analim 3000M

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

Andrew Mawson - 13 Feb 2009 22:53 GMT

Anyone experience of the Analim 3000M CNC control ? Is it a good 'un
or a pain in the neck? I'm looking at a CNC mill equipped with one but
have no experience of that particular controller.

AWEM

Reply to this Message

mark@ems-fife.co.uk - 14 Feb 2009 22:28 GMT

On 13 Feb, 22:53, "Andrew Mawson"
<andrew@no_spam_please_mawson.org.uk> wrote:

> Anyone experience of the Analim 3000M CNC control ? Is it a good 'un
> or a pain in the neck? I'm looking at a CNC mill equipped with one but
> have no experience of that particular controller.
>
> AWEM

I know guys who have run older Analims for years and they seem easy to
work with.The problems begin when you get a problem,used spares are
virtually non existent and there does not seem to be a lot of open/
free info available for these controls.You can download manuals for
programming from their site but I don`t think there is any fault
finding or maintenance info available.For these reasons that makes all
Anilams an "avoid" control for me.

Reply to this Message

Andrew Mawson - 15 Feb 2009 00:03 GMT

> On 13 Feb, 22:53, "Andrew Mawson"
> <andrew@no_spam_please_mawson.org.uk> wrote:
[quoted text clipped - 11 lines]
> finding or maintenance info available.For these reasons that makes all
> Anilams an "avoid" control for me.

Thanks Mark, I consider my card marked!

AWEM

Reply to this Message

Model Forum / General / Models / February 2009

Analim 3000M