Victoria / elliott universal dividing head, information on gears wanted

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

mick vann - 19 Feb 2010 00:15 GMT

Hi Chaps, would anyone happen to have a Victoria or Elliott Universal
dividing head, that has the gearing to fit to the milling table feed to
enable helical milling.

I am after a set of gears or information on the sizes and dp of the gears.
Any info would be helpfull especially a manual in electronic form.
Regards Mick

url:http://www.myreader.co.uk/gp/1348-1.aspx

Reply to this Message

Drawfiler - 19 Feb 2010 21:56 GMT

On Feb 19, 12:15 am, "mick vann"<albertbigbollo...@ratherhairy.com>
wrote:

> Hi Chaps, would anyone happen to have a Victoria or Elliott Universal
> dividing head, that has the gearing to fit to the milling table feed to
[quoted text clipped - 5 lines]
>
> url:http://www.myreader.co.uk/gp/1348-1.aspx

Go onto ebay and find a seller called Fazerblazer, he is a guy from
Leicester who has the stuff you want, if that fails PM me and I will
sort you out, you will also need aquadrant. BTW I can make the gears
if you need them.
Peter

Reply to this Message

Charles - 19 Feb 2010 22:02 GMT

> On Feb 19, 12:15 am, "mick vann"<albertbigbollo...@ratherhairy.com>
> wrote:
[quoted text clipped - 14 lines]
> if you need them.
> Peter

Or buy a whole dividing head library on CD or £6.75 here:

http://www.metoolsonline.com/product_info.php?products_id=4

Charles

Reply to this Message

mickv - 23 Feb 2010 18:13 GMT

Thanks for the links, I did try faserblazer, I requested a listing of
the contents pages for the elliott dividing head and Elliott omnimil but
he said he "was unable to help me", even though he was selling them on
his ebay site. So not a lot of help there.

Does anyone know the dp for the universal head, the bore is 1". regards
Mick

Signature

mickv

Reply to this Message

Richard Shute - 24 Feb 2010 09:46 GMT

>Thanks for the links, I did try faserblazer, I requested a listing of
>the contents pages for the elliott dividing head and Elliott omnimil but
[quoted text clipped - 3 lines]
>Does anyone know the dp for the universal head, the bore is 1". regards
>Mick

Mick,
send me a PM, I have the Elliot DH manual, 'though not the miller one.

Richard

--- news://freenews.netfront.net/ - complaints: news@netfront.net ---

Reply to this Message

Model Forum / General / Models / February 2010

Victoria / elliott universal dividing head, information on gears wanted