Model Forum / Radio Controlled / Air Models / December 2003

I bought a used Senior Telemaster and need plans or instruction book.
The plane is yellow with Hobby Lobby black logo on the wings. The
wings are 2 piece but the dihedral braces and joiner pieces are
missing. I just am looking for plans/instructions so I can get this

I need some fiberglass rods 1/8 inch X 48. Any sugestions?  Thanks Eddie Fulmer

Would anyone know of a source for a good set of plans for a 1/3 scale
Nieuport 11 (or plans that could be enlarged to 1/3 scale)?
Happy Holidays!
Mike

I have a poly dihedral glider.    The manual says I should have the wing
tips approx 110mm  off the ground.   There are fixed sized wedges under the
wingtip joining braces.   Im about to glue the wings together, and one tip
is 112mm off the ground and the other is 114mm off the ...

Just attempted to cover a wing with some ulracote plus that i purchase
a while back.  This is the type of ultracote that is tacky on th
adhesive side to help in positioning and then ironed down.  I've bee
monokoting and ultracoting for quite awhile now and I have neve

Anyone know of a way to turn wind "on" in this sim? Need to work on my cross
wind landing technique.

   In building battery packs, I prefer to use the braided material to
connect the batteries to each other in the pack rather than the tabs because
the braid will hold up to vibration better.
   However, I see that the braided wire runs about .30 or .40 cents an inch

I would like to build a radio controlled glider, but the stores tell me that
"they" have stopped selling plans! "They" only make pre-made gliders that
you put together! The thing is.. I want to build it from plans on paper....
Does anyone have any info on where I can get some plans? ...

I have to go to work for just four days in January.  One of them just
happens to be..?  The Watford swapmeet day.  Now what are the odds eh?
B*st*rd
D

I found a site for buiding planes with coroplast. To clean they says
to use mineral spirit. What it ist ? Is it naphta or what else.
I am a french canadian.

For Real Flight G2
http://www.realflight.com/wright-flyer/index.html
For Flying Model Simulator
http://www.freewebs.com/fmsusers/downloadsplane.htm

Need help in doing Knife Edge spins, can someone tell me how to do these
please?
Thanks,
flierbk

Hi, Are parts interchangeable between OS 46 SF and OS 46FX? Like piston/sleeve?
Crank? Head? Carb? Backplate? I have a good running but crashed 46 FX and an
old worn out 46 SF. Thought maybe I could get somethig working here. TIA, Dan.

Can anybody tell me correct placement for a fuel tank relative to the engine
and is it critical to the nearest couple of millimeters?
Thank you

http://www.j-walk.com/other/wifispray/
It might improve range!
David