Model Forum / Radio Controlled / Air Models / July 2005

Help, I need exploded view of fuel pump for Os fs-70 engine. Thx.

Can anyone help me with setting up / using a Pro-Peak Constellation charger.
I have just bought one and the manual is useless.  All I want to do is to
have some control over charging and cycling my TX & RX nicad packs but all
the charger wants to do is auto-mode slow charging / ...

My Pro Peak Super Nova has bitten the dust after about 4 years use. The
touch pad buttons are  intermittent and the left hand button doesn'y work at
all. This means that although I can cycle through the programms using the RH
button only, I can't discharge/cycle my packs as the ...

Visited your website last night. Thanks for putting the history of your
planes on it, most enjoyable but more important, it motivated me. I was down
in the dumps after loosing 2 aircraft due to pilot error. Seeing your
history (meant respectfully) I have some catching up to do. I am ...

Check the RC P-51D Mustang model on MinervaHobby.
_________________________________________________________^M
Posted via the -Web to Usenet- forums at http://forums.yourdomain.com^M
Visit www.yourdomain.com and try our New products and services today!

The summer solstice is just around the corner (perhaps the summer is
as well ??? )
In anticipation of the coming building season I have ordered the plan
for a Ben Buckle   Super 60. I have already built the Challenger and just

My Mutunuc (sp??) engine runs ok-ish but could do with just a little more
screwing in of the main needle-but there's the problem-the needle is already
screwed right in and wont go any more....
A passing 'expert' reckons an air leak (where??)-any thoughts/cures??

I am new to this group and have been lurking for the past couple of
weeks and have enjoyed the information so far (in particular SPAD).  I
have built R/C models in the past and have recently decided to get back
into it.

I have a new in the box kit for an ElectriCub that came with a ThrustMaster
550. Models span is 59", weight about 3 lb's.. I'd like to upgrade to
today's electric motor. What would be a good replacement for the
Thrustmaster 550.?

Fellow R/C'rs:
Correct me if I am wrong, but almost every receiver antenna that I
have run across is usually one meter long...that is 39 nches, give or
take.  I checked my 27 and 50 and 72 mhz receivers, both Futaba and JR

just had a quick google with out a lot of success, does any one know the
typical dimensions a seagull, span, weight, wing area and loading etc?
I thought it might be interesting to make a few comparisons with our own
sport.

Just got a new (used) Futaba 8UAF? transmitter on e-bay.  In reading
there seems to be 2 methods of operation, PCM, and FM.  I currently use
an FM Tx, Rx, and standard servos.  Will I need to get a new Rx?
Servos???  What is the advantage if any with PCM?  Will I just need to

There I was down from the hills and stood on a lonely stretch of
beach. One of my winter projects was poised on its wheels ready
to go, or not as the case may be !
A Heron glider, which had been lost and found again, had been out in the

Red bull have started action against people for using thier colour scheme on
model aircraft. They have threatened litigation to people such as
composite.com for daring to copy thier paint scheme.
Pretentious prats.....

Hi, my question is, would the temperature of 95º F cause my 3S, 1500
MaH battery to give two third the normal flight time of about 18
minutes for a fully charged battery?
My flights were normal in that sometimes fast, sometimes slow and easy.