Model Forum / Radio Controlled / Air Models / July 2005

Anyone have any suggestions on what engine I can use to power my somethin'
extra. It used to have a super tiger 51 in it before I bought it. I was
looking at the Thunder Tiger 46 Pro and the Super Tiger 51.

Can anyone recommend a part number and UK source for ferrite rings or beads
suitable for servo leads?  I can find some on Maplins site but the
specification table is so badly formatted that I can't figure out which ones
are OK for our small gauge servo wires.

After years of monitoring your newsgroup , Ive  always found answers there
without needing to post--- until now.
After sterling service, one of my Twinjet Jamara 480 motors has died. Time
for an upgrade!

Hoping it lasts long enough to be a problem!
I'm putting together a Seagull Razzle. Does anybody have any tips on
how to effectively fuelproof the front end of it.
There is a front former hole for the tank connections and likely

I have an ARF that I need to trim some covering off to install the tail
etc.  It says to trim it carefully to make sure you don't cut the wood
underneath.  I've read that this is nearly impossible to do.  Are there
any tricks to cutting the covering without slicing up the balsa, or ...

For what it's worth...I just received a couple of the 8 and 6 channel
Seeker receivers from Polks...priced right and bench tests are very
good..using either Hitec, JR or Futaba.  My only complaint would be
the very thin wire used for the antenna... I plan to test fly them

Can anyone enlighten me - what the correct ratio of fuel to oil is????  Its
still running in - most have told me 40:1 others 50:1  some even 25:1 and
one guy 100:1 !!!!!!!!!
Its a newish Zenoah G23

I just picked up a 40 size Sig Kadet kit at at flea market and the
plans are missing...does anyone have a spare set of plans that they
would like to sell me?? I'd really like to get this kit built.

come here,all famous brand watch(reproduct)
http://www.famousbrandwatch.com

I'm a relative newcomer to flying, only started last year.  I bought
the X-Peak 3 field charger which I believe is a badged version of the
Ripmax Pro Peak Prodigy  charger.  I remember reading in this forum
last year that someone had heard from Ripmax that this charger was

My father recently had a pacemaker implanted in his chest and he is upset
that he may have to give up his beloved hobby. I know it probably depends on
the model of pacemaker he has and also the type of transmitter he uses- but
if someone could give me some general info or tell me ...

Hello Fellows:
I recently built the H9 US 40. I have the complete building and
programming instruction (for Futaba 9C) written up, and I will post
them soon.

£9 entrance fee
A bit steep ?

When doing a roll combined with full elevator (snap roll?) it obviously
behaves a little differently depending on whether it was full-up or full
down on the elevator but you still get the same general over-all effect.
But what is the right way to do it? Is there a certain reason ...

Any one out there who know how to come in to service mode on the (SANWA)
Airtronic RD8000
It is in Mode 1 and i want it turned in to mode 2.Anyone out there who
know