Model Forum / Radio Controlled / Air Models / April 2006

Apologies if this question has been asked before.
Does anyone know what has happened to the Nexus Plans Service (RCM & E)?
Has anyone else taken over the 'rights' for these plans.
Thanks

I am about to paint a plane using the Sig Super Coat.
The plane is covered with Kover-All and prepped with nitrate dope.
My question is can I put different colors on top of each other with the
Super Coat (butyrate dope) or will the second coat melt the first coat and

I have the GP Red Bull foamie ready to build, but no glue yet.  Since I
don't live near a hobby shop to buy foam safe ca glue, can anyone suggest
another type of glue I can use safely on depron.
Thanks

When I were lad,  people used to fly toy aeroplanes at Nomansland common near
Wheathamstead / Harpenden.  I am occasionally in that area and I wondered if
it's still permitted, and if so then what is the protocol and which areas of the
common do people still use ?

While looking for various models for FMS I ran accross a "Guppy" and  
variations thereof on the  
http://kimagure-hikoki.hp.infoseek.co.jp/Hanger2/Hanger2_index.html  
website.

Anyone have a Serial # for Clear View RC Sim 435 ??  Thanks

It will take 3 weeks to make Gene Pitney a casket from solid oak,
But only 24 hours from balsa !

Trying to decide on an electric starter plane for myself and my 11 yr old
twins to learn on.I want to stick to electric at least for now.I live in the
country,lots of room .I have 3 acres backing on to my in-laws 100 acres.We
also have to deal with wind a lot.(light wind is all I ...

I'd like to attach a micro actuator to a thin carbon fiber plate in such
a way that I can remove it (unglue) again and use it on another plane.
Any sovent used should not attack the insulation on the magnet wire of
the coil.

I have a very simple Air Hog F-16 Falcon R/C plane.  Basically, it's
just a small styrofoam plane with a small motor and fuel pack, which
connect to two propellers via a wire.  The  make is basic enough that
I'm wondering if I can buy these parts seperately at a hobby store and

Hey all,
I have a Combat Wings XE2 with a Hitec 555 receiver being controlled with an
Airtronics RD6000 Super.  The elevator works normally, but the ailerons are
reversed.  When I use the servo reversing on the transmitter, the elevator

Does anyone know what's happened to them?, their site is dead and they
usually have a spring show about now.
Greg

The forecast was for sunny intervals and windspeeds of 7 mph.
Plane had been charged in advance. Sarnies were quickly knocked up
and off I went having also packed a diesel power pod 'cos of the
light wind.