Model Forum / Radio Controlled / Air Models / June 2006

I'd like to fit retracts to my plane. Except... I'm a bit clueless about
retracts. The main issue I want to solve is covering the wheel wells when
the wheels are retracted. Configuration will be with steerable front wheel
and the usual two wheels in the wings.

I am just finishing up a new 4 Star 60 and am having difficulty deciding
where/how to set the Ailerons in the neutral position. Would appreciate some
advice from a 4 Star flyer/builder.
Do you set the ailerons even/level with the lower back portion of the wing

I bought this Li Poly battery, my very first one over three years ago.
It is a Thunderpower 3S1P. I've had good service from it, over
hundreds of flights. After an unfortunate crash, I installed it into
another plane and nothing happened.

I measured it twice to double confirm.
Measured from left side of the firewall to the center of motor mount
stick == 50 mm.
Measured from right side of the firewall to the center of motor mount

Has anyone got a circuit diagram of the Futaba T6EXA transmitter?

The battery level meter of my 6XA it is indicating a smaller voltage of
the than the voltage of the battery, does anybody know as I can repair
this?
Mano

Has anyone got a circuit diagram of the Futaba T6EXA transmitter?

I recently took apart and cleaned the carb on my ST 75 and have noticed that
the carb barrel seems to be more difficult to move. When I loosen the two
small screws that hold the spray bar in place, the barrel frees up but when
I tighten them down, it is more difficult to move. I ...

I have just bought my first li-poly battery (kokam 910 3s1p).
This does not have any leads fitted so I will have to solder my own
power leads and the harness for the balancer.
In a previous thread, mention was made that soldering li-poly cells

Just bought my first MP-3 Player and downloaded some music on
www.tunster.com?
These guys are really cheap! All albums for around $ 1,- and they seem
to have it all!