Model Forum / Radio Controlled / Air Models / May 2008

Anyone know where I can find a set of plans (or even an old kit)  to
Lou Andrews (AAMCO) MiniMaster?  I tried on the AMA plans site but
could not find the plans...and it is hard to navigate, too...IMHO.
Frank Schwartz

  I have an older Futaba Gold RC Trans. and another Futaba box that was
piggy backed as a buddy box , the buddy box has a single RCA plug that was
tied to my main Transmitter via wire , wondering if I could feed this unit
into the USB port and run a Flight Simulator on my PC, ...

I have acquired an Aspect Aviation Hyperbee and would like suggestions on an
engine for this plane.
I'm looking for a .15 size engine that will turn a 8X7 prop at least 16,000
rpm. This should provide approx 100mph.

Zeno’s Warbird Video Drive-In May 2008 Newsletter
Hello RCers --
You’re invited to drop by Zeno’s Drive-In www.zenoswarbirdvideos.com
and sample this month’s outstanding lineup of World War 2 plane videos

I stripped out the glow plug threads on my  Webra speed 50 last week and
sent I sent the head to Lee Custom Engines for a helicoil.  It was back in
monday's mail(TX to CA and back). Put it on the engine and test ran it
today.

I have a Wasp V3 and had a minor crash. There are two connecting rods
that connect the main rotor blades to SOMETHING. I can't figure out
what. I have called the distributor and they are Chinese and can
hardly speak english so they are no help. The manual shows an exploded

I just bought two RTF birds, one Heli and One jet. They both came with
chargers that will charge 2 or 3 cell batteries and are labeled as
"balanced".. One is DC and the other is AC/DC . The input voltage and
output amperage is equal on both. The AC charger is much faster than

I am looking to strap a minDV camera to a small RC plane or helicopter
for some aerial shots - any suggestions for someone on a tighter
budget?

Please?
On the fuselage, the bottom strut that begins at the tail, and ends up
at the front of the plane,  is SPLICED... from BASS, to BALSA. I
assume that it is to ease the bending that's required. The balsa

Please?
On the fuselage, the bottom strut that begins at the tail, and ends up
at the front of the plane,  is SPLICED... from BASS, to BALSA. I
assume that it is to ease the bending that's required. The balsa

Test