Model Forum / Radio Controlled / Helicopters / January 2006

My Caliber 30 has a JR X378 radio. The transmitter fully charged shows
about 11 volts. After 2 tanks of fuel, it's down to 9.8 or a little
lower. What is a good minimum to use???
The reason I'm asking is that it's pushing 3 years old and I want to

Can anyone give me some pointers on how to set up the gyro gain properly
with Reflex XTR on my Futaba T8UHFS (FF8) controller?
I want to use switch F, which I've set in the radio, and set the ATV gains
to their fullest extents (which it only lets me set to 30% - 100%).  Then

please contact me if you have a copy of Reflex Sim
greg@websavey.com

Can anybody point me to a few good 60-size or even 90-size electric? For
instance, is a Raptor 60 available in electric, or are there conversion
kits? I'm mainly interested in scale-like flying, not the hot 3D stuff.
Thanks for any pointers.

Can anyone recommend a good gyro and servo setup for the trex?
It is a stock 450xl with the 420LF3200 motor.
Thanks in advance.

Well, less than 48 hours after stating I couldn't afford a new RC sim,
I've found myself in the position of selling my G2 to my
brother-in-law (who's ressurecting his Kalt Whisper) so I'm looking to
get a new sim.

The most beautiful brides from Russia and Ukraines http://dating.ru/?dating=1241

Dear Newsgroup.
I have one of thos little fixed-pitch electric helicopters from E-sky.
I haven't actually flown it yet as I haven't had anywhere to go.
All I want to know really, is what to adjust and check before flight,

I am trying to setup my Hornet 2 with speed controller, and I saw that it is
recommended that
separate control of pitch and throttle is best for using governor function.
I try to assign separate stick and volume with FNC function on my 9ZHP,

I'm in the stinks with this Lipoly Movment, I Bought an E_Sky smart
charger that is totally retarded or the number one cell in my Lipo
Battery is Crap.  I suspect the E_SKy smart charger because the lipo
pack arrived with an even voltage reading on all 3 cells, 4.1 volts

Does anybody know how to make a Parallel cable that works with FMS?
My TX is an E-sky 4ch unit (ET104C).
In your opinion, which is the best simulator for Heli flying practise?
One more thing. Have you got a TX > PC cable, does it work, and where

    I want to make a plastic toy.  Specifically the blades of a
helicopter.  What kind of plastic do I need to use?  I think I can get
epoxy resin and the curing agent.
Could you guys give me some insight into how you make your plastic