Model Forum / Radio Controlled / Helicopters / December 2007

Hi I have a blade 2 heli and I landed it too hard and sheared of the pins
that the lower blades set on.  Is there somewere to get instructions for
dismantle and reassemble so I don't pull too many screws or parts and forget
how they came off?

someone can send to me ? Receiver is broken !
Thanks !

I am really interested in learning to fly rotary wing models -
specifically Collective Pitch helis.
I'm based in Glasgow City and have transportation.
What's a good club to go to for CP heli tuition?

Hi I have a rotor head that I need to disassemble but has the very strong
(permanent) threadlock liquid holding it together. Does anyone know of a
threadlock remover that wont spoil anodised aluminium?
Thanks - Gaz

I have just ordered the following three books:
The basics of Radio Control Helicopters
ISBN: 0911295364
Radio Controlled Helicopters: The Guide to Building and Flying R/c

can someone describe me (exactly) how to producing M-Blades
(Aluminium Blades?
And what kind of machine('s) it need to do so?
Here a link to the M-Blades Site: http://www.m-blades.com

Here are a few videos from some of the guys/gals I fly with. check
these out:
- 2007 Highlights with the group I fly with:
http://media.putfile.com/Circus-2007-Highlights

Just arrived my new Spectrum DX7 and Phoenix Sim - Heli to follow after a
lot of hours on the sim :-;
---
Dave Scott

I have an eflight cx2.  The remote that came with it has a switch in the top
left corner labled trn.
There is no reference to it in the manual.  Could someone educate me a
little about it?

Hi all.  New to this group.
I haven't done any RC flying since I flew RC fixed wing years ago.
Always been curious about helicopters.
I flew the realflight g2 simulator for a while and then took the