| Thread | Last Post | Replies |
|
| Electrics and governor mode | 31 May 2008 15:42 GMT | 8 |
I've got myself a T-Rex 450 SE V2. The user's manual and the experienced guys say to not use the governor mode which the ESC supports. The experienced guys say it's because the ESC gets too hot, while the manual gives no reason at all.
|
| what's the history of 3D flying? | 30 May 2008 17:32 GMT | 10 |
Quick background...my first introduction to heli's was when I was a kid (about 1980 +- a few) and saw a guy hovering at the local school yard on summer day. Forgot all about it until a couple years later when I saw folks
|
| RC GOOD BUY no regrets :) | 29 May 2008 20:03 GMT | 1 |
Check out.. http://www.hobbycity.com?cda=516
|
| 735 Set RC Heli - Spinning Out of Control Solution | 23 May 2008 15:02 GMT | 1 |
I've finally managed to solve my problem where the Trimming Knob was maxed out and still I had to use stick left to keep the heli from spinning to the right. In my case, I just twisted the bottom rotor blades (lightly by hand),
|
| Helicopter Magazines | 22 May 2008 03:18 GMT | 4 |
Can anyone please tell me of other radio controll helicopter magazines other than " Model helicopter World " and " RotorWorld " as i`m curious thats all.
 Signature Regards,
|
| Just got 1 trex600 Nitro Pro | 15 May 2008 19:47 GMT | 8 |
Very excited Just got 1 trex600 Nitro Pro for helipross trex600 For 489 a set these are very cheap Heliken
|
| Trex 450 Tail Drive | 12 May 2008 22:11 GMT | 28 |
Does anyone know of a shaft tail rotor drive upgrade for a Trex 450. I have had the belt snap for the second time in about 6 months. It makes for a terrible landing. I don't mind the cost of the part's it is just such a pain to get the wreck back to the preferred setup before the ...
|
| Where to buy | 06 May 2008 19:17 GMT | 20 |
I need a hex start shaft that has a shaft length of 9 inches so the starter cup sits above the rotor head when placed in position. There is not enough room to tilt the shaft as it passes through the elevator control yoke which only has a small hole and the amount of tilt required ...
|
| Helipro Blackhawk 500... gone for ever? | 06 May 2008 19:17 GMT | 27 |
Only store in Australia stocking it does not stock the heli anymore. The parts they sell show "out of stock" for some items which is no biggie, we find it hard to get soem stuff that is plentiful in USA or asia etc. BUT I see those are also out of stock on some overseas websites.
|
| Help me , Please! | 05 May 2008 23:10 GMT | 49 |
I just purchased a 735 AirSquire mini-helicopter. Right out of the box and for the first ten minutes or so of flight, it worked fine. Shortly thereafter, the helicopter started to spin out-of-control to the right and would no longer fly. The more throttle I gave, the faster the
|