Model Forum / Radio Controlled / Land Models / December 2005

I have all parts for the following KYOSHO BUGGIES:
Landjump
Vanning
Mint Las Vegas

Are there 50mhz module available for Futaba 3PK?  Can I use the ones
for 9C(FP-TP-FM) on 3PK?
Thanks

Anyone reccomend any for a new nitro user? Book reccomendations welcome too.

Where would I find this out? Would it be stamped on the car anywhere? It is
nitro and has a calibra touring car shell if it helps.As I took it out
yesterday and crashed it spectacularly and got away with just having to
straighten the half shaft. Next time though I might not be so ...

Im pretty much a noobie (dont hate me for it), and just curious on how
can I tell if im getting the right mixture (rich/lean).  I've adjusted
(as the engine manual says) during the ""break-in"" process, and
wondering if your suppose to see the exhaust (blue smoke) when ...

bought myself my first real rc car a tmaxx. before all i had was radio
shack crap. But i also was given a Nikko dictator about 7 years ago. I loved
it but about a year later a i broke it. Now getting back into the hobby i
take it back out to see what is wrong and if i can fix it. I ...

I bought a Compeition Electronics Pit Bull charger through the mail
order side.  It arrived and I found the seal broken and the connecting
wire ends were twisted showing it had been wired to something before.  I
call Customer Service and the guy says, "yeah, alot of that stuff is ...

Anyone used one?
Any info?

I purchased a TM323 for my revo...initially ran like a raped ape,
changed fuel, and hasn't run since. can't find any fuel
obstructions,SEEMS to have adequate compression,using seperate glow
ignitor with new rb plug, just doesn't want to fire. has plenty of fuel

I'm looking at cleaning and rebuilding the gearboxes and diffs, what's the
best way of cleaning them?
Paggle

So tell me what you think about the build quality of it. Fit- finish any
out of box issues?
I have one and it doesnt seem to meet my expectations of a LOSI product.

I've got a Team Orion Element 19 turn spec motor, (the one with the angled
brushes.)
Problem is this:  I cannot get the solder to adhere to the tabs.  What is
the best way to do it?

I ran my monster gt recently through grass and gravel that had an inch
of snow cover.  I noticed that it seemed rough when going through the
snow.  It was about 25F that day.  I figure that the snow was cooling
the engine too much.  It ran as if I just started it up and drove

Specifically, for my Sav and my 4.6...
Basically - the ribbed pipe - is absolutely DEAFENING.  Seriously, and this
is compared to the RB i had on before that was not by any stretch of the
imagination, quiet.  Sooooo my Sav just cost me more money and because I

I am after a left rear arm for my frog has anyone got one of these that ya
wanna sell?
Thanks..Damien