Model Forum / General / Models / April 2005

wanting to buy their  mickey dome for monogram'1/48 b17 any sellers?

I really cannot wait for this one. It is one of my top ten favorite movies.
The original was a George Pal masterpiece.
Quoted from SciFi.com
Stephen Sommers, director of The Mummy and Van Helsing, will write and

The end is near for one of the most beautiful jet fighters in the world:
The Saab Viggen.
With just 8 more moths to go only one squadron still operates the Viggen in
two recce variants and an electronic warfare version. On 5 - 6 April I had

Is there any members from Guildford Model Engineers read these pages

Had an inspiration while stuck in traffic the other day,  I wanted to make
some boat parts requiring accurate cross drilling through a turned part,  I
only have a lathe(s) and pillar drill to go at. Normally I would either muck
about with vertical slide or more often than not use ...

Don't want to spend too much, any suggestions?
Graha
--
Grahammo

Can someone indicate the thinest v depth section that can sensibly be
cast using the lost wax process. Alternatively could someone direct me
to PD information on this topic?

I have just aquired one of these units and am at the moment checking it
out.Does anyone on this group know where I can get information on this
machine(I have the manual) and also a supplier of tools and carbide tips for
same.I am also lookiing for a 300m/m length of 35m/m o/d thick ...

I've been scouring google for ages looking for some large washers,
thought I'd ask here because I've came up with nothing.
I'm looking for large washers that will fit onto a 1" diameter bar and
2" diameter bar, I want to use them as micro dumbell plates.

Hi, I am looking for a strong glue for aluminium - let's say strong
enough to prevent someone from opening a glued sliding window!
I have looked on Google, and found a couple of epoxy-based glues, both
several hour curing and short (6-min) curing variants.

I'm quite new to this and found this NG through a google search. I was
looking into the prospect of buying one of these lathe/mill combo
machines but as there seem to be so many similar machines on the
market I was looking for a little bit of advice. Chester and Warco

I'm asking this for a friend. The 1968 Shelby GT-500 . Did it have twin
white stripes in the centre of the car going from the hood, over the
passenger compartment and finishing on the trunk?
I hope someone can answer this.

I need some help finding a GOOD archive for A.B.M.S. from like JAN or
FEB 2004.  Looking for a picture I uploaded, but the file was zapped.
Specifically, an Aregentina A-4B 1/48.  E-mail if you have any help.
PLEASE!  rdouglascoxNOSPAM@mindspring.com

hgmhgmgj