Model Forum / General / Models / June 2005

New Hobby shop recently opened in Clarksville. It's at 10 Main St (the
Riverside end). They guy has a pretty good split between RC and
plastic, with the plastic selection leaning towards cars and trucks.
He's new to the area, so he's not sure yet what he wants to get in the

Any ideas on best "scale" stuff to use for aerial wire?  Stretched sprue
doesn't look right, human hair is in short supply nowadays, sewing
thread looks too big, etc etc
G

Just checked out the local Hobby Lobby.  I can pick this kit up for
about $40.  I was wondering if anyone had any experience with it.
Thanks

Hi all, hope you had a good day as well. When sorting through a
cupboard of potential scrap found a plastic bag with a nearly new 3 jaw
Bison in it. Can't remember getting it but it was obviously too big for
the lathes I had at the time and I must have put it away safely. The

READING THIS COULD CHANGE YOUR LIFE! IT DOES WORK!
I found this on a bulletin board and decided to try it. A little while
back, I was browsing through newsgroups, just like you are now and came
across an article similar to this that said you could make thousands of

Does anyone know if the issue of licensing fees being paid to defense
contractors was passed also?

Been away from RMS for almost the better part of two years and finally
am back on the proverbial saddle again.  Moved back to heaven (Austin,
Texas) from DC, and am I glad I am back!!!
Cheers,